View Single Post
  #4  
Old 06-14-2022, 01:00 PM
Chris Railey Chris Railey is offline
Enthusiast
 
Join Date: May 2021
Location: Waynesboro, Georgia
Posts: 60
I saw guy at blade doing press demos with an induction forge. I have also seen the guy over at Black Bear Forge's youtube channel forge with one. They are very fast and much safer IMO for demos. Plus, its already 100 degrees in the shade here so not super heating my shop would be nice as well. The thing I like best about an induction forge is you can isolate and heat a specific part of your steel. You can heat the center part of a bar and bend it too without using a oxy/acetylene torch. Great setup Ed.
Reply With Quote