Thread: Clip point
View Single Post
  #3  
Old 05-16-2020, 04:51 AM
Tex65 Tex65 is offline
Enthusiast
 
Join Date: Jul 2019
Location: Austin Texas
Posts: 81
Quote:
Originally Posted by jimmontg View Post
That looks pretty good, the finish on the blade looks like you got the previous grit scratch lines out as the really start to show up around 1000 grit. Nice job Tex, but you're still letting your pins get a little close to the edge. Otherwise it looks very good Tex.
I still mostly use templates I found online. I went back and looked and most of them have the pins too close to the edge. I’ll be checking and adjusting the layout from now on. Someone suggested 3/16 from the edge. As always thanks for looking and the advice.
Reply With Quote