Custom Knives | Other Knives | General Items
New Posts | New PhotosAll Photos

Go Back   The Knife Network Forums : Knife Making Discussions > Gary Roberts

Conversation Between Gary Roberts and jellyroll
Showing Visitor Messages 1 to 1 of 1
  1. jellyroll
    01-13-2015 10:59 PM
    Hey Gary,
    Looked we had a bad connection on the phone today and thanks for trying to call. I wasn't sure if you got my email address, but try me at
    I tried laying it flat tonight and I still don't think it works well. I put a nice edge on it from my Arkansas translucent stone and then tried lightly and slowly stropping it flat on the strop. After 2 passes I checked it and I know it wasn't better and perhaps slightly (very slightly) less sharp, so I dec##ed to stop (at least it will cut at this point). Now I can tell I have a noticeable burr, but I am curious if its possible to run the knife backwards on the stone to r## the burr instead of using my strop? I've never done that before and not sure if its even a good move.


All times are GMT -5. The time now is 12:50 PM.

Copyright © 2000
? CKK Industries, Inc. ? All Rights Reserved
Powered by ...

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
The Knife Network : All Rights Reserved