Custom Knives | Other Knives | General Items
New Posts | New PhotosAll Photos

Go Back   The Knife Network Forums : Knife Making Discussions > ArtinNC

Conversation Between ArtinNC and hartswave
Showing Visitor Messages 1 to 4 of 4
  1. hartswave
    02-01-2014 09:14 PM
    Hi Art, thanks for the response. Sorry I haven't responded sooner. I live at 9100Ft in Frisco, Co. and since my last post I have gotten 3Ft of snow so have been busy with that and have finished 2 more knives. The pics are in my album. One is a smaller knife for a trucker friend, and the other is a fishing knife for a lady flyfisher woman. Take a look and see what ya think.
  2. ArtinNC
    01-24-2014 06:33 PM
    Scott where do you live ?
    I'm in NC .
  3. ArtinNC
    01-24-2014 06:31 PM
    I have a knife that I made in 1992 that I stuck it in a fence post and thought I had lost it and after3 months I found it and it showed a little red that wiped off with a little oil on it . And you can't see any rust yet today . But I have used super glue under the bolsters and if you do wear a face shield because the super glue will splatter. Really if you have a good tight fit I don't think you need it . Or when you clean the knife put a little WD40 by the bolster and wipe off the access.
  4. hartswave
    01-24-2014 02:46 PM
    Hey Art, you make some killer knives. If you don't mind, what do you use under your bolsters for a water seal?

All times are GMT -5. The time now is 10:20 AM.

Copyright © 2000
? CKK Industries, Inc. ? All Rights Reserved
Powered by ...

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2023, Jelsoft Enterprises Ltd.
The Knife Network : All Rights Reserved