|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Drill bit sizes?
What size bit should I get to drill pin holes?
If I use a 1/4 cobalt bit to drill my pin holes it's just to tight. So, what bits should I order for. 1/8 3/32 5/32 1/4 I know they are #'s but what are they? I'm getting tired of drilling holes twice. Thanks |
Tags |
advice, brass, diamond, digital, drill, education, grinder, handle, handle material, heat, heat treatment, hone, knifemaker, material, mosaic, movie, pins, press, sand, simple, steel, supply, tiny, tools, wood |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Making a drill press out of hand drill | remist17 | The Newbies Arena | 5 | 12-03-2012 09:39 PM |
Pivot Pin Sizes | DAN VAN | The Folding Knife (& Switchblade) Forum | 10 | 05-20-2008 09:45 AM |
Belt sizes | Doug Lester | Tool Time | 10 | 12-28-2006 08:11 PM |
What tap sizes | alexkuzn | The Folding Knife (& Switchblade) Forum | 5 | 01-01-2006 09:01 AM |
Leather sizes | DC KNIVES | The Sheath/Holster Makers Forum | 10 | 02-21-2002 04:48 PM |