|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Forging question
Yesterday I challenged myself to draw out a scrap of spring steel into a small skinner for a friend. Most if it went well. I drew the width. I set base choil area. I “banana” it down. When i fot to the tip it was thinner than Im used to and refused to turn a belly. I ended up with a sheepsfoot
Any advice is welcome. __________________ Do not go gentle into that good night, Old age should burn and rave at close of day; Rage, rage against the dying of the light. -Dylan thomas |
Tags |
advice, art, base, beginner, bending, blade, ca, edge, finish, forging, grinder, hammer, heat, knife, make, profile, question, skinner, small, steel, thickness, wood |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gemstone Question and Finishing Question | Fiferguy | The Newbies Arena | 4 | 08-13-2002 09:26 AM |