|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
| The Newbies Arena Are you new to knife making? Here is all the help you will need. |
 |
|
|
Thread Tools | Display Modes |
|
#1
05-20-2014, 08:19 PM
|
|||
|
|||
|
Just finished Dad's new knife
I'm gonna hand deliver this knife to my Dad for fathers day down In Arkansas.
OAL, 9". Blade 4.375" Handle 4.687", Blade width 1.312", Blade thickness .150" at the choil. Slight distal taper. Steel S35VN to 60RC, convex ground, Satin finish, tapered tang, Black liners, Handle, Stabilized Honduran Rosewood, mosaic pins, stainless thong hole. My sheath. __________________ Scott Last edited by hartswave; 10-12-2014 at 01:54 PM. 
|
|
| Tags |
| blade, hand, handle, knife, make, mosaic, pins, rosewood, satin finish, sheath, stainless, steel, tang, tapered tang, thickness |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| introduction and my dad's father's day gift. | dankingery | The Newbies Arena | 3 | 07-31-2010 01:07 PM |
| Dad's Birthday | Crex | Georgia Knifemaker's Guild | 5 | 05-04-2010 12:40 AM |
| The sunset over Dad's Shop | Kevin G Warner | Knife Photography Discussion | 13 | 01-24-2002 07:51 AM |
Linear Mode
