|
|
The Display Case A place to post your latest knives and creations. Let the Knife Network community see your work first! |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Fresh from the shop: "the Raptor"
I have just finishhed this piece and wanted to show it to the "world". Handle is Amboina and the steel is ATS-34 1/4". grooves and holes are mirropolished by hand, flats are handrubbed to 400 grit and hollows are handrubbed to 800 grit. When I fininish the sheath it will be sharpened on both edges. let me know what you think! |
#2
|
|||
|
|||
It looks mean, Jens! How big is it? |
#3
|
|||
|
|||
Holy Cow Jens, that is one wild looking knife. I don't even want to think about sharpening it. Can you post a pic of the sheath when done as well? ghostdog |
#4
|
|||
|
|||
Jens, looks great! Also looks like the same batch of Ambonia I got when you have the sheath ready you should show a new picture, also show the original consept drawing you did on Rhino3d! a start to finish (before after kind of thing) |
#5
|
|||
|
|||
Thanks for all the nice replies. I was one tough bugger to grind.....had to handfinish most since the finer grits on the beltgrinder was very hard for me to control. And yes...it has bitten me a few times...that point is Dangerous! here is the working drawing: and here is a pic of it in my hand (note: it is not finished in this pic): it measures about 3" from tip to the small hole just behind the edges |
Tags |
knife |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
(View-All) Members who have read this thread : 2 | |
Sallet, Seemus7 |
|
|