|
|
Knife Making Discussions A place to discuss issues related to all aspects of the custom knifemaking community. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Need Some Blade Blanks???
I'm a certified newbie and would like to make few "semi-custom" knives, but am not ready to invest in an oven. I'm looking for someone to make me a 7.5-8 in. total length (3-4 in. blade) drop point hunter blank blade, already hardened so I can customize with finish, guards, spacers, scales, etc. I already have the sketch done and would prefer a high quality steel (154CM, ATS34, S30v, ???).
Can this be done without breaking the bank? Any recommendations on who would work with me on this project? |
#2
|
||||
|
||||
Flat grind or hollow? Can you post a pic of your sketch?
|
#3
|
|||
|
|||
ReverendPDP
My name is Jeff Turner and I am a knife maker(ARTIST) with Center Cross. Center Cross is the parent to the UKK, which stands for the Ultimate Knife kit where we are offering JUST WHAT YOU NEED, as a great friend and founder of Center Cross, Gene Osborn once said! You can further check us out at www.centercross.com, I guarantee that we will be able to supply you with just that. If you would like you can reach me by my personal email patriotdesign@rocketmail.com, thanks for checking us out! |
#4
|
||||
|
||||
The blades at Center Cross may be more than you were thinking about spending, but probably not any more than I would charge, and much higher quality.
|
Tags |
blade, custom, guards, hunter, kit, knife, knife kit, knives, newbie, post, scales, supply |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Finishing blade blanks | hopinjon | The Newbies Arena | 9 | 02-02-2008 10:26 PM |
Finishing blade blanks | hopinjon | The Watering Hole | 0 | 01-31-2008 06:40 PM |
Blade Blanks | hopinjon | The Newbies Arena | 8 | 01-31-2008 06:31 PM |