|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
Knife Making Discussions A place to discuss issues related to all aspects of the custom knifemaking community. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Stainless Damascus Bolster ?
I am planning on using some Mike Norris stainless damasus for the bolsters on a stainless damascus blade. My first thought was to use 416 pins, peen them in, sand them smooth and then etch along with the rest of the knife. I am worried that the 416 might react differently to the muriatic acid than the Mike norris damascus. How do you pin and etch stainless damascus bolsters?
Thanks Steve __________________ Stephen Vanderkolff Please come on over and check out my website. http://www.vanderkolffknives.com/ Thanks |
Tags |
blade, damascus, knife |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Damascus Bolster Question | DC KNIVES | The Folding Knife (& Switchblade) Forum | 1 | 08-11-2007 11:51 PM |
gold inlayed damascus bolster | ron p. nott | Fine Embellishment | 12 | 11-09-2002 08:48 PM |
Oosic & Damascus Hunter w/ Bolster | J.Arthur Loose | The Display Case | 8 | 10-01-2002 09:03 AM |
Blues Damascus bolster | Big DB | Fit & Finish | 4 | 02-19-2002 08:33 PM |