|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
heat treat
Hey guys figured i would post a new thread since the last one has turned into a book...anyway i was away for a few days and since i been back i have been coming up with a few designs as ''prototypes" that if they work out well ill make a few more and sell them...people already asking me for a while and i feel combtorable taking someones money now so anyway i was HTing them yesterday the liquid nitrogen over night now tempering everything....i may have run into a problem maybe not? i put the blades in the even heat oven at 350 well i checked on it a min or 2 later and it was all the way up to 381 it immediately started going down but i have never seed the oven go so far above the set temp it may varry a few degrees but never seen it that off....do you guys think this will have a big effect on the temper or maybe not since it was only for a min? ohh its 440c steel
|
Tags |
440c, back, bee, blade, blades, book, buy, degrees, design, heat, heat treat, knife, knives, make, making, post, problem, sand, sell, shop, show, steel, stone, throw |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
o1 heat treat | blitt214 | Heat Treating and Metallurgy | 1 | 09-18-2013 02:33 PM |
Re-Heat Treat? | mrgantz | Heat Treating and Metallurgy | 4 | 02-12-2010 03:42 AM |
heat treat? | cwiehle0 | The Newbies Arena | 18 | 11-30-2008 10:07 PM |
Hi new guy here to heat treat | twistedneck | Heat Treating and Metallurgy | 2 | 12-03-2005 01:03 AM |
What do I need to heat treat with? | Andrew Quigley | Heat Treating and Metallurgy | 2 | 10-12-2005 01:58 PM |