Here's a another one. - The Knife Network Forums : Knife Making Discussions

Kevster · #1 02-08-2014, 10:06 PM

I ground this one out today. This one is 1095 with filework. I think I'm going to try to edge quench this one, so any info on edge quenching would be appreciated.

Kevster · #2 02-09-2014, 12:22 PM

Here's the hamon I got on the 1095.

Kevster · #3 02-09-2014, 06:46 PM

Kevster · #4 02-10-2014, 05:55 AM

Quote:

Originally Posted by JeremyRayTurner

~ looking good.....impressive......you talk like a novice but your work gives another impression ~ well done ~ what product did you use on your blade prior to the heat to get the hamon ~ !

Thanks, the steel is 1095 and I used satinite to get the hamon.

Ray Rogers · #5 02-10-2014, 08:49 AM

Kevin, why did you etch your logo before doing the HT? If you wait until the blade is finished you'll get a much nicer looking mark ...

Kevster · #6 02-10-2014, 10:32 AM

Quote:

Originally Posted by Ray Rogers

Kevin, why did you etch your logo before doing the HT? If you wait until the blade is finished you'll get a much nicer looking mark ...

Cuz I'm a rookie.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)