|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
Tool Time Let's talk shop. Equipment, Tips & Tricks, Safety issues - Post it here. |
|
Thread Tools | Display Modes |
#16
|
|||
|
|||
Sam,
I'm planning on using the spring loaded lever that was on my little Delta 1"belt x 5"Disc sander they had for the table lock down. I will just use the nut and bolt arrangement for the Delta. I will either tack weld a bolt to the back side of the Kalamazoo table for the lever to go onto or use a special bolt (possibly off the Delta, I have to look at it) that grabs the inside of the hole with "ridges". You could always purchase a spring loaded lever handle from somewhere. I'll let you know what method of attachment I use. DAVID |
Tags |
bee, belt, belts, blades, brand, building, carbon, design, easy, flat, grinder, grinding, hand, heat, heat treatment, knife, knife making, make, making, material, motor, newbie, sanding, sharpening, steel |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bench grinder into belt grinder? | nutball | Tool Time | 12 | 03-29-2023 01:49 PM |
Bench grinder vs. Belt grinder | stillwaters | The Newbies Arena | 7 | 03-13-2013 05:36 AM |
What is the difference between a belt sander and belt grinder? | nifeknut | Tool Time | 2 | 11-30-2004 12:01 PM |
belt grinder | bulldogsblades | Tool Time | 13 | 04-02-2004 06:12 PM |