Rise and Fall indicator

[Txcwboy]

I obtained the material to make a rise and fall indicator but I dont know any details or dimensions . Any plans out there ?

thanks

Dave

[CWKnifeman]

Dave I'll send the measurements later, Busy today Wifes birthday.
Curtis

[zerogee]

Here's what Curtis posted to the Texas Toothpick thread:
http://ckdforums.com/forum/showpost....&postcount=370

[CWKnifeman]

Thanks zerogee, I forgot that I had posted the total measurments on the toothpick thread.
Curtis

[zerogee]

Here's a little different configuration made by Bill Vining, with enough measurements given to figure out the rest - I think this is essentially the same as the Ruple design: http://bkgtools.medawebs.com/ - note the instruction manual link - worth downloading. I think Bill has stopped making these though.

[Don Robinson]

I've made a few of these for other knifemakers in addition to mine. If Frank doesn't want to sell them any longer, I might be talked into making one.