|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
My first experience with 01 (now with pic)
My take on 01 tool steel? This stuff is amazing! Especially during heat treat. I heated the blade just a bit past non magnetic quenched it, let it air cool then put it in the oven for two hour long cycles on 415 degrees wrapped in tin foil and it came out a straw color with some purple and dark blue inclusions in places.
Uploaded with ImageShack.com Actually this is a bad pic, the straw color and purples are much more prominent than this shows. Wow, this stuff sure beats the heck out of straightening leaf springs which may or may not be 5160. But it's a lot more expensive too, 3 feet of ground 01 for $31.50. What other steels have these properties but are a little cheaper? Last edited by Hurley; 11-05-2013 at 10:06 AM. |
Tags |
1084, 1095, 5160, back, blade, blades, edge, file, forge, grinding, hamon, harden, heat, heat treat, knife, knives, made, make, quenched, simple, steel, stock removal |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A learning experience | BrianT | Ed Caffrey's Workshop | 3 | 03-16-2009 01:06 PM |
My first forging experience | Andrew Garrett | Knife Making Discussions | 14 | 02-06-2007 12:02 AM |
Bad epoxy experience. | alexkuzn | The Newbies Arena | 11 | 07-03-2006 09:51 PM |
KMG and 1.5 HP motor experience | alexkuzn | The Newbies Arena | 13 | 09-07-2005 11:53 PM |
Experience required? | pupandcat | The Outpost | 2 | 03-06-2002 10:31 AM |