|
|
Fine Embellishment Everything from hand engraving and scrimshaw to filework and carving. The fine art end of the knifemaker's craft. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Etching steel
What steels can you do a deep etch in? I was going to use ferric chloric. Can you do stainless steels like 304, or 416?
|
Tags |
acid, etch, etching, hand, knife, maker's mark, material, post, steel, wax |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Electrochemical Etching Stainless Steel Problems | jeffm | Knife Network Community | 3 | 05-09-2012 07:26 PM |
Etching or Darkening Steel | Dana Acker | The Outpost | 6 | 12-10-2003 12:09 PM |
hard and soft steel etching? | crowknives | The Newbies Arena | 11 | 03-27-2002 08:11 PM |