|
|
The Supply Center What's Hot ... and where the deals are! Supplies are our specialty ... |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Need copper rivets
I am looking for round or dome head copper rivets. The length can be anything from 1/2" or longer with an 1/8" shank. I could also use brass or bronze to. Most suppliers sell them in 3-500 quantities, I only need 25-50 at the most.
Last edited by B.Finnigan; 05-23-2006 at 11:55 AM. |
#2
|
||||
|
||||
is it a 2 piece rivot? a shaft and washer ?
Dave |
#3
|
||||
|
||||
#4
|
||||
|
||||
I am looking for the dome head that you pein on the other end. May just bite the bullet and get a package of 500. That is more than I will ever use in a lifetime.
|
#5
|
||||
|
||||
Somebody will need some. You could offer to split an order in barter town over at PF. Chuck Burrows has or had a load of brass tacks he trimmed down that way. I usually just buy copper ground wire from the hardware and cut and head it as needed.
__________________ "Many are chosen, but few are Pict" "The doer alone, learneth" NT Neo-Devo |
#6
|
||||
|
||||
#7
|
||||
|
||||
Thanks! That is pretty close to what I was loking for and tehy are in packs of 10 vs 500. I will email them to find out the length.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|