|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| The Outpost This forum is dedicated to all who share a love for, and a desire to make good knives, and have fun doing it. We represent a diverse group of smiths and knifemakers who bring numerous methods to their craft. |
 |
|
|
Thread Tools | Display Modes |
|
#1
09-01-2006, 05:13 PM
|
|||
|
|||
JB Weld
More than one person has been singing the praises of JB Weld lately on this and another board that I post to so I was wondering, do you think that it would adhere rams horn and other types of horn to a tang. I understand that horn can be tricky to glue.
Doug Lester 
|
|
#2
09-01-2006, 08:36 PM
|
||||
|
||||
|
It will work fine, but you will have a grey line if you join 2 slabs together. There is a good glue discussion in the general knife discussions area that may give you some better options.
__________________ Steve Shiffer Fear causes hesitation, hesitation will cause your greatest fear to come true. 
|
|
#3
09-01-2006, 09:07 PM
|
||||
|
||||
|
Use the two part clear epoxy as it is thinner and will leave practically little or no line at the glue point and your horn will look great. Nothing against JB weld as I use it for some things and if you don't mind the gray line then it is fine for use.
|
|
| Tags |
| knife |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
