|
|
The Folding Knife (& Switchblade) Forum The materials, techniques and the designing of folding knives. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Rotary Table size?
May I get some input on a rotary table from you guys? I am going to buy one to try my hand at folders. I want to use it to make the circular slot for the stop pin. My mill is not mini but not full size either. It is a Grizzly 8x30. I assume I don't want the cheapest. Should I get a 6" or an 8". Is Vertex a decent brand? How about the Enco Phase II?
|
Tags |
bee, brand, buy, ca, cheap, hand, knives, make, makers, making, mill, pivot, question, small, tiny, tool |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rotary table question | SVanderkolff | Tool Time | 4 | 05-03-2012 07:49 AM |
Table 24-E, Our Table at Blade 2010 | RandyScott | Georgia Knifemaker's Guild | 4 | 06-03-2010 01:24 PM |
air rotary tool or micro motor rotary tool | anderskniv | Fine Embellishment | 5 | 03-08-2009 10:23 AM |
Rotary Table~What have you used it for? | Tbonz | Tool Time | 3 | 07-20-2004 10:50 PM |