![]() |
![]() |
![]() |
|
![]() |
![]() |
||
![]() |
![]() |
|
![]() |
|
The Damascus Forum The art and study of Damascus steel making. |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
layering metals......billet making
I would like to know if you are using 1095 and 15n20 to make a billet does it matter whicH
![]() MBA.......... ![]() |
#2
|
|||
|
|||
I would make sure the 1095 or the thickest metal is the start and end of the billet. Thinner on outside will bend away making that piece harder to weld to billet.
|
#3
|
|||
|
|||
Thanks for that info.............it makes sense having the thickest metal on the outside.
Mba |
#4
|
|||
|
|||
I use 1080 and 15n20. If you are going to weld ,draw out, cut, and restack to gain layers.I start with one and end with the other. If you doen't you will have a wider layer with each piece you stack.
Take care TJ Smith __________________ TJ Smith Knifemaker |
![]() |
Tags |
1095, 15n20, a, art, bend, billet, make, making, metal, steel, thin, weld |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Etching different metals | Eli Jensen | The Newbies Arena | 5 | 01-18-2012 06:40 AM |
Metals | Foxjaw | The Outpost | 23 | 11-01-2007 11:09 PM |
Damascus Steel Billet, Blank,blade, Knife Making Supply | ancientarms | The Damascus Forum | 2 | 12-15-2005 08:42 AM |
Transmutation of metals | Misternatural? | The Outpost | 4 | 05-15-2003 07:37 PM |
What metals for engraving? | Bob Sigmon | Fine Embellishment | 18 | 08-26-2002 10:57 PM |