|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
So, I build a HT oven
A couple of people mentioned in another thread that they wanted to see some pictures of a HT oven I built. So, here is a design I made in SketchUp and the final result. I took pictures throughout the build to chronicle the steps along the way, so I might just put up a thread at a later time for that.
-Dan |
Tags |
build, design, drill, easy, firebrick, heat, jig, kaowool, made, making, project, rod, small, tools |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
NWG build | newbie13 | The Newbies Arena | 0 | 04-23-2014 02:47 PM |
To BUILD or To BUY?? | CJS Knives | Heat Treating and Metallurgy | 11 | 04-17-2012 08:44 PM |
Here,s one i did for a build off | FOG2 | The Display Case | 0 | 07-28-2009 03:29 PM |