|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
D/C motor
Hello All, I am new to this site. I make a UGLY knife worthy of only the dirtest scrap barrel and have plenty of questions. I am sure this has been covered a million times on this site but I could not find any mention in the earlier messages. I am looking for a variable speed D/C motor to make a small grinder. I have heard that there are some 2-1/2 HP that are rather cheap but I did not have an address to go with the information. Does anyone have a source for this type of motor? Thanks, Gary |
#2
|
|||
|
|||
Here ar a few to start you off; www.dealerselectric.com www.roysstore.com/ groban.mfg@att.net These are computer frienly and have some great pricing. KEN (WWJD) |
#3
|
|||
|
|||
Here's a thread on a cheap 2.5HP. I ordered one and they are much smaller than one would expect. It is "treadmill duty".I plan on making a disk sander with it. pub42.ezboard.com/fcustomknifedirectoryforumfrm14.showMessage?topicI D=104.topic |
#4
|
|||
|
|||
Thanks!
Thank you both for the info. Now I need to go look up this information. |
Tags |
knife |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
(View-All) Members who have read this thread : 1 | |
warren |
Thread Tools | |
Display Modes | |
|
|