|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Finally some of my work...
I want to take a moment to thank everyone on this forum for all your help, a special thanks goes out to Ray, who has taken the time to answer everyone of my questions no matter how stupid I felt, he took the time to explain stuff. There are several others that have also taken the time to answer questions and I say thank you to them. My work is still very very beginner but I am learning with each knife I do. For those of you who remember, my first was the letter opener ( I put a picture of it when I was working it, and one finished, then I have 3 that are almost ready for HT (sending out) and one That is just shaped. All but the letter opener are .188 thick 440c stainless. Like I said, these are very very beginner, but I am still proud and wanted to thank you all for your help.
Jay Z |
#2
|
|||
|
|||
Oh yea, any helpful remarks would be greatly appreciated, on the one with only one hole in it, still needs holes and I think I'm gonna try a bolster as I started by blade to far up (first time using a jig I made)
|
#3
|
||||
|
||||
You've learned a lot grasshopper and I think you're about to learn a lot more ...
Last edited by Ray Rogers; 09-20-2012 at 03:18 PM. |
#4
|
|||
|
|||
Looks like you have a good start on those blades. It will be interesting to see them finished.
Doug __________________ If you're not making mistakes then you're not trying hard enough |
#5
|
||||
|
||||
I agree! Those look great so far and it will be interesting to see them finished. You will keep learning with each and every blade you make. I know I am still
|
#6
|
||||
|
||||
Go Jay-Z!
__________________ Carl Rechsteiner, Bladesmith Georgia Custom Knifemakers Guild, Charter Member Knifemakers Guild, voting member Registered Master Artist - GA Council for the Arts C Rex Custom Knives Blade Show Table 6-H |
#7
|
|||
|
|||
I love the look of the high finish blades. Great knives!!
|
#8
|
|||
|
|||
Thank You
Thanks to everyone here for all the help and encouragement along the way. I will show these off once they are done...
|
Tags |
art, blade, jig, knife, knives, made, make |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Finally done... | Zimba | The Sheath/Holster Makers Forum | 3 | 04-14-2008 08:51 PM |
finally | Omega | The Outpost | 16 | 12-31-2006 05:23 PM |
Finally. :) | luc | The Display Case | 12 | 07-18-2005 12:07 PM |
Finally done... | nifeman | The Display Case | 3 | 09-22-2004 06:46 AM |
metal work sheath work available | SVanderkolff | Knife Making Discussions | 0 | 02-15-2004 08:01 PM |