|
|
Fit & Finish Fit and Finish = the difference in "good art" and "fine art." Join in, as we discuss the fine art of finish and embellishment. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Correct Size Corby Bolt
Hi All
I just received a TBS Bushmaster Boar knife blade that I need to put a handle on. The tang has three holes that measure 6.05mm (0.238 or 15/64 in). That is 12 thousands under 1/4". In two of the holes I would like to put Corby bolts, and a lanyard pin in the 3rd hole. But, I'll be ####ed if I can find the correct size bolt little lone the lanyard pin. Most Corby bolts I find are to big, having a 1/4" shaft. I find some smaller but they seem too small like 3/16" WTF! The question is two fold really, First, is there a supplier that has what I need? and second, how small is too small? I would guess that I should only have about 3 thou "slop" in my pins. Any help would be great! Cheers Bill Last edited by Willyd57; 09-21-2018 at 11:07 PM. |
Tags |
a, advice, blade, ca, diamond, epoxy, files, handle, hardware, heat treat, knife, knife blade, lanyard, loveless, made, mosaic, pins, problem, question, sand, screw, screws, stainless, supply, tang |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
help with corby bolt | mr.HC | Fit & Finish | 9 | 01-24-2017 02:33 PM |
Corby Bolt Issue | kjd2121 | The Newbies Arena | 3 | 08-21-2011 06:56 PM |
pivot bolt size | joe sangster | The Folding Knife (& Switchblade) Forum | 10 | 10-07-2006 01:22 AM |
Corby Rivets vs Hidden Bolt Fasteners | cavetech | The Newbies Arena | 6 | 12-27-2005 01:05 PM |
Printing Correct Picture Size | Johnny Stout | Knife Photography Discussion | 2 | 05-09-2004 06:21 AM |