|
|
The Supply Center What's Hot ... and where the deals are! Supplies are our specialty ... |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1" contact wheels
Looking to make a 1" horizontal belt grinder and looking for the contact wheels, can anyone hepl?
Frank |
#2
|
|||
|
|||
Contact Bader. Dave
|
#3
|
||||
|
||||
Found this on Ebay
http://cgi.ebay.com/NEW-dynabrade-11...QQcmdZViewItem __________________ Andy Garrett https://www.facebook.com/GarrettKnives?ref=hl Charter Member - Kansas Custom Knifemaker's Association www.kansasknives.org "Drawing your knife from its sheath and using it in the presence of others should be an event complete with oos, ahhs, and questions." |
#4
|
|||
|
|||
All the 1" contact wheels I have seen can only run for about 5 min. or so. What I did to beat that was used a 3/4" dia. shaft (turned the shaft down to 5/8 and 3/8) with 2 pillow blocks and backstand idler and put a piece of rubber tubing on the shaft and now I can run it for hrs. You could use a 5/8 shaft and then use the rubber hose which I got at Auto Zone.
Here is a picture of my grinder and how I did it so you can get and idea. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|