|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
Heat Treating and Metallurgy Discussion of heat treatment and metallurgy in knife making. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
HT for S30V sword
:confused:
Dose anyone know of some one who can heat treat a sword made of s30v? I have talked with Paul Bos but he only treats blades 32" and shorter. I made one that is longer. Thanks Dan |
#2
|
||||
|
||||
That will a real trick. The quench is within grasp but a furnace deep enough is not something likely found within the custom community. If mine I believe I would be contacting those that make production knives. Your sword will need to be soaked consistantly at about 1925 to 1960 F for quite a few minutes. It will also need to be protected from oxygen during all that time.
It'll be a hell of a sword though. I'll give you that. RL |
Tags |
knives |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|