|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Bolsters
I’ve been practicing attaching bolsters to scrap of blade steel, and I’m getting pretty good and consistent results. I’m to the point where I feel like I can attach them to a blade and end up with a presentable product.
My question is this. What if anything is everyone using to attach the bolsters to the scale besides the peening of the pins? I’ve seen epoxy used, solder, nothing... I’m just curious what those with experience have used with the best results. Thank you |
Tags |
a, bee, blade, bolster, bolsters, ca, clean, collecting, epoxy, flat, glue, knife, metal, pins, question, scale, scales, solder, steel, surface, tang, tips, weld |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
bolsters | gharper@awesome | The Newbies Arena | 1 | 09-15-2006 07:55 PM |
Bolsters on or off? | Russ Sutton | Fine Embellishment | 2 | 10-27-2005 12:55 PM |
? for Don re bolsters | SVanderkolff | The Newbies Arena | 1 | 12-08-2002 04:22 PM |
Bolsters | RickNJ | Fit & Finish | 3 | 06-28-2002 09:56 PM |