|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
High-Performance Blades Sharing ideas for getting the most out of our steel. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How to finish and sharpen your knifes with a Lansky sharpener
This is the way I sharpen and finish my knives before they go out the door.
How do you guys do it? Thomas https://youtu.be/jSSuziQw6Jo |
#2
|
||||
|
||||
Nice video, thanks for sharing. I take a similar approach that has a fixed clamp that holds the blade for use on the Burr King. A well used 400 or 320 grit belt that at this stage approximates ~800 or 600 grit due to wear at a very low RPM. After the edge is set, a few passes on leather impregnated with white buffing compound.
I used to enjoy the challenge of stoning them freehand. I'd felt that this was a necessary part of learning to sharpen properly. Now and then I bring them out to see if I can still hold an angle but far and few between these days. Read that as way out of practice. __________________ Mike |
Tags |
a, angle, belt, blade, burr king, ca, edge, finish, fixed, how to, knife, knives, leather, video, white |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to sharpen with a Lansky system | TJuhler | Tool Time | 1 | 01-23-2018 04:14 PM |
Sharpen Angle? | Walt- | The Newbies Arena | 8 | 01-05-2014 04:19 AM |
Lansky Shapening system | Wazukie | The Newbies Arena | 10 | 10-24-2013 09:15 PM |
Lansky sharpening sistem? | Dane | Factory Knife & Mid-Tech Discussion | 6 | 06-03-2009 09:31 AM |
i just cant sharpen to save myself. | Brett Holmes | The Newbies Arena | 14 | 11-23-2005 07:07 PM |