|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Heat Treating and Metallurgy Discussion of heat treatment and metallurgy in knife making. |
|
|
Thread Tools | Display Modes |
|
#1
08-09-2020, 05:22 PM
|
|||
|
|||
|
Temper line question
I have been making knives from various steel for about 20 years I like and mostly use 52100 . Generally without problem but the last one I made Has a beautiful temper line on the right side and NONE on the left side same steel same treatment as in the past. Could some of yall help out a little. I use a torch to harden quench then an oven to temper Ive done this for more than 10 tears without problem. Hobby maker no power hammer just like making knives
|
| Tags |
| 52100, bearing, bee, coating, flat, hammer, harden, hobby, knife, knives, made, making, photo, power hammer, problem, question, steel, temper |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| temper line | rasp181 | The Newbies Arena | 2 | 01-27-2007 01:38 AM |
| Paint pen temper line??? | titaniumdoctor | Knife Making Discussions | 7 | 06-15-2006 01:12 PM |
| Need HELP w/temper line!!!!!! | Mace | Knife Making Discussions | 2 | 03-15-2004 08:36 PM |
| temper line? | Gary Mulkey | High-Performance Blades | 4 | 02-20-2002 09:33 AM |
| Temper Line | Metalpressr | Ed Caffrey's Workshop | 2 | 05-08-2001 11:48 PM |
Threaded Mode