I've got a question about copper bar stock.

[Kevster]

I can get the copper bar stock from Jantz, how come they don't sell pins to match?

Can I go to hobby lobby and get pins for this bar stock? Is it the same? Or does copper really matter?

Thanks

[Ray Rogers]

There are different alloys of copper but I don't think I would worry about it much. Copper pin stock usually isn't hard to find. If Jantz doesn't have it then look at some of the other suppliers....

[Doug Lester]

Go to a hardware store and look for bare copper wire. You will have to straighten it but that shouldn't be too bad. A hobby shop may have it too.

Doug

[BCROB]

hobby store sells all kinds , make your own mosiac with copper tube and misc alloys, whatever else you can imagine
also copper corbys available for added handle security.....

these are brass of course just do the same in copper , I just dont have a pic at the moment to post of copper

[Kevster]

Originally Posted by BCROB

hobby store sells all kinds , make your own mosiac with copper tube and misc alloys, whatever else you can imagine
also copper corbys available for added handle security.....

these are brass of course just do the same in copper , I just dont have a pic at the moment to post of copper

I need small pins, say 3/32 to 1/8 for bolsters.

[Ray Rogers]

Any hobby shop should have that small pin stock and probably most hardware stores too ...

[mwhuston]

Originally Posted by BCROB

hobby store sells all kinds , make your own mosiac with copper tube and misc alloys, whatever else you can imagine
also copper corbys available for added handle security.....

these are brass of course just do the same in copper , I just dont have a pic at the moment to post of copper

Those are pretty nice. How do you fill the 'empty' space? Do you use an epoxy?