![]() |
![]() |
![]() |
|
![]() |
![]() |
||
![]() |
![]() |
|
![]() |
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
![]() |
|
Thread Tools | Display Modes |
#16
|
|||
|
|||
Quote:
|
#17
|
||||
|
||||
I'm not sure what you mean by 'alone'. A fair part od whether or not it might work depends on the overall design of the burner. Personally, on my Dirt Simple burner - which is pretty darned simple - I prefer a 2:1 ratio although I have no reason tho think that any other ratio would fail completely. USA Knife Makers has a simple venturi that actually has no venturi at all but appears to work just fine ...
|
#18
|
|||
|
|||
Yes Ray, my new forge from them has no venturi, just a piece of pipe with the gas nozzle centered about 1/4" away from the end and it works fine. Though it does start to sputter about every 10 min and I have to adjust the regulator. It may be that my gas is almost gone too. But it get REAL hot! Past forge welding temps!
Last edited by Hurley; 12-28-2013 at 02:56 PM. |
![]() |
Tags |
acid, art, cleaning, design, drill, epoxy, forge, glue, heat, iron, knife, make, metal, pins, pistol, problem, scales, simple |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Venturi Burner? | Pelallito | The Newbies Arena | 8 | 09-01-2009 05:46 PM |
A Dirt Simple Venturi Burner | Ray Rogers | The Newbies Arena | 5 | 09-05-2007 08:40 AM |
Wrought Iron, Bubble Alumina, Hard Firebricks, Venturi Burner Kits | Darren Ellis | The Supply Center | 0 | 07-31-2005 11:24 PM |
burner question | Don Halter | Tool Time | 10 | 07-14-2002 09:16 PM |