![]() |
![]() |
![]() |
|
![]() |
![]() |
||
![]() |
![]() |
|
![]() |
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
Ed Caffrey's Workshop Talk to Ed Caffrey ... The Montana Bladesmith! Tips, tricks and more from an ABS Mastersmith. |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Update on Your Rolling Mill
Greetings Ed,
You have had the rolling mill now for over 6 months. What are your thoughts having this added to your tool collection? Pros? Cons? Regards, Dennis Paish |
#2
|
||||
|
||||
Sorry for the lag Dennis! I replied once, but I guess I goofed up and didn't actually post it.
In the last several months working with the rolling mill, my opinion is that its a "nice to have" thing, but its far from a "must have". It draws out stock quickly, but thats about its best point. Its not something I would spend the time and effort to build if I had a good press (which I do). Mostly because building a decent one is gona mean a LOT of precision. I've had to adjust/shim the rollers on this one several times, and its still not "right". Running stock through it at even a few degrees off 90 causes terrible curves, which are a bear to get out once the stock is less then 3/8" thick. Probably the area where I like the press the most is when it comes to the initial drawing out, after the first weld on a billet of damascus. Just a couple of heats and its ready to grind/cut/restack. As I've always told others, when it comes to using a rolling mill AFTER patterning, I simply don't. After just a couple of passes through the rollers, everything turns into chevron. Which isn't bad if you want a chevron pattern, but it makes ladders into chevrons, and turns pool-n-eye into "teardrop" pattern. Overall its a handy tool to have, but had this one not already been built, and came with the press, knowing what I do now, I wouldn't spend the time/effort on building one. __________________ WWW.CAFFREYKNIVES.NET ![]() Caffreyknives@gmail.com "Every CHOICE has a CONSEQUENCE, and all your CONSEQUENCES are a result of your CHOICES." |
#3
|
|||
|
|||
Greetings,
Thanks Ed. DP |
![]() |
Tags |
bee, billet, build, building, damascus, degrees, grind, mill, post, press, rolling, weld |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rolling Mill | BrianT35 | Tool Time | 10 | 05-27-2002 07:14 AM |
Re: Rolling Mill | MDHoffmann | Tool Time | 8 | 05-19-2001 08:26 PM |
Rolling Mill | MDHoffmann | Tool Time | 2 | 05-03-2001 02:15 PM |
Rolling Mill | MDHoffmann | Ed Caffrey's Workshop | 3 | 05-03-2001 05:57 AM |
Rolling Mill | Sweany | Tool Time | 14 | 04-03-2001 08:50 PM |