|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Heat Treating and Metallurgy Discussion of heat treatment and metallurgy in knife making. |
 |
|
|
Thread Tools | Display Modes |
|
#1
08-21-2005, 05:35 PM
|
||||
|
||||
|
5160 for stock removal
I know Wayne Goddard loves this stuff because of it's strength when properly HTd. Can it be used to good effect as a stock removal only steel as well?
Andy __________________ Andy Garrett https://www.facebook.com/GarrettKnives?ref=hl Charter Member - Kansas Custom Knifemaker's Association www.kansasknives.org "Drawing your knife from its sheath and using it in the presence of others should be an event complete with oos, ahhs, and questions." 
|
|
#3
08-22-2005, 12:24 AM
|
||||
|
||||
|
Thanks. Any idea where to get some without buying a 20' bar of it from Admiral?
Andy __________________ Andy Garrett https://www.facebook.com/GarrettKnives?ref=hl Charter Member - Kansas Custom Knifemaker's Association www.kansasknives.org "Drawing your knife from its sheath and using it in the presence of others should be an event complete with oos, ahhs, and questions."
|
|
| Tags |
| forge |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
