|
|
Heat Treating and Metallurgy Discussion of heat treatment and metallurgy in knife making. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Heat Treating Damasteel
I aquired some Damasteel at the Oklahoma show this past September and have no idea how to HT it.
I have a KM-24 and intend to plate quench in foil. ...little help? __________________ Andy Garrett https://www.facebook.com/GarrettKnives?ref=hl Charter Member - Kansas Custom Knifemaker's Association www.kansasknives.org "Drawing your knife from its sheath and using it in the presence of others should be an event complete with oos, ahhs, and questions." |
#2
|
||||
|
||||
Andy
I heat treat it the same as 440C and have had good results. I also use quench plates and treat it in foil so that should also work fine. Steve __________________ Stephen Vanderkolff Please come on over and check out my website. http://www.vanderkolffknives.com/ Thanks |
#3
|
||||
|
||||
scroll down to the 93x .y steel and take a look att the HT data sheet they?ve got.
http://www.damasteel.com/steelgrades.html /Roger __________________ Life is to short to own an ugly gun or knife. |
#4
|
||||
|
||||
Thanks fellas.
__________________ Andy Garrett https://www.facebook.com/GarrettKnives?ref=hl Charter Member - Kansas Custom Knifemaker's Association www.kansasknives.org "Drawing your knife from its sheath and using it in the presence of others should be an event complete with oos, ahhs, and questions." |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|