|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Heat Treating and Metallurgy Discussion of heat treatment and metallurgy in knife making. |
|
|
Thread Tools | Display Modes |
|
#1
05-17-2012, 03:49 PM
|
|||
|
|||
|
Olympic and Evenheat Kiln
I am looking at getting a kiln to HT my knives and I am looking at the Olympic Model 1823FL, the Evenheat KO 22.5, or the Evenheat KF 27. When I said I was looking at getting a kiln my wife asked if there were ones that I could HT my knifes in and she could do some pottery work in witch is why I was looking at the Olympic, because of the greater volume. I have herd good things about the Evenheat but I have not herd much about the Olympic for HT. I would like to know what there ramp speed is and how long they take to get to 2000f. Also does the ramp speed of the kiln increase if you take up some of the volume with firebrick? Thanks.
|
| Tags |
| back, brand, buck, design, heat, heat treat, knives, newbie |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FYI - Sealing the Evenheat kf22.5 kiln | twistedneck | Heat Treating and Metallurgy | 2 | 07-22-2006 04:28 PM |
| Evenheat Kiln + Argon | twistedneck | Heat Treating and Metallurgy | 6 | 02-22-2006 08:45 PM |
| A NEW EVENHEAT KILN $480 vs $1000.....read on... | Colin Paterson | Ed Caffrey's Workshop | 5 | 07-25-2005 06:42 PM |
| NEW $1000 Evenheat KILN for $480.... read on! | Colin Paterson | Knife Network Community | 0 | 07-20-2005 10:34 PM |
Threaded Mode