|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
|
Thread Tools | Display Modes |
|
#1
06-01-2016, 07:05 PM
|
|||
|
|||
|
Help on knifemaking
So I'm relatively inexperienced with knifemaking. I've made a few that aren't too bad. But I don't have a mentor and I'm pretty much flying by the seat of my pants. When I grind my blades, I don't set a specific angle or have one in mind, I just kinda hope for the best. What should I be doing to match the angle I drew to what I'm getting? Is there a good way to figure out what angle I should grind to achieve it?
|
| Tags |
| advice, angle, art, back, belt, belts, bevel, blade, blades, convex grind, edge, grind, grinder, hand, jig, knife, knifemaker, knifemaking, knives, made, making, mentor, sharp, steel |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help on knifemaking | Wolfe_Man | General ::: Items and Bargains | 0 | 06-01-2016 06:33 PM |
| You can take the man out of knifemaking... | John | The Display Case | 5 | 08-13-2008 12:31 PM |
| New Knifemaking FAQ available | Bob Warner | The Newbies Arena | 35 | 10-26-2006 01:00 PM |
| New to knifemaking! | TechMasterJason | The Newbies Arena | 2 | 04-05-2002 06:44 PM |
| Knifemaking CD | Don Cowles | General ::: Items and Bargains | 4 | 02-26-2002 10:06 PM |
Threaded Mode