|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
0-1 Hardening Question
I finally ground a couple of blades im satisfied with. And have instructions from an old post on how to heat treat using basic equipment. My question is, if using a torch to heat the steel to non magnetic how long must you hold it at that temp before you quench in the oil? |
#2
|
|||
|
|||
On tool steels like O-1 you don't need to soak it in the heat. As soon as it is non-magnetic or just a little over it can be quenched. I'm not sure if you doing an edge quench but make sure the whole edge is non-magnetic and the same color. Not to hard on a smaller blade but much more difficult on a large one...Ray |
Tags |
blade, knife |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
(View-All) Members who have read this thread : 2 | |
coldtracker, warren |
|
|