|
|
Knife Making Discussions A place to discuss issues related to all aspects of the custom knifemaking community. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
anyone make fillet blades?
Hi guys.
Ray Rogers suggested I try you lot. I am looking for 2 stick tang fillet blades. 23 across the tang and around 150-160 across with a small ricasso. Obviously it would need to be stailnless (44oC?), thin and flexible. they would been to come fully finished and ready to mount, and be sharpened in a way that would make the edge easy to maintain on a flat stone, whilst on a boat. The blades supplied for fillet knives usually are far too narrow ( around 15-18 mm across the tang. I'd like something wider. Is there anyone who can help and make these 2 blades for me. ? if the is can you mail me with prices and delivery times. i am based in Norway. Thanks guys. __________________ Mut When the going gets tough, the tough throw it away and start again! Last edited by Mut; 03-24-2004 at 05:09 AM. |
#2
|
|||
|
|||
Thanks to those who were in touch about these.
The commission has gone to george tichborne. Thanks George. look forward to getting the blades. __________________ Mut When the going gets tough, the tough throw it away and start again! |
Tags |
blade, knives |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|