|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
hello from Tennessee
I wanted to say hello and thanks for the wonderful resource I'm hoping I can post a pic of my EDC it is made of CSS (coil spring steel) Chevy truck so probably 5160 the blade is 4" hollow ground fully hand forged shape then of course a visit to my grinder I'm proud to carry it daily I also did the simple sheath for it .
|
#2
|
||||
|
||||
A lot of creativity went into that, nice job! I'm not so sure about that sheath design but it too looks well made. Use the knife for all the hard jobs you have to do for the next year or so. Then tell us what you would change about it, if anything ....
|
Tags |
5160, blades, coil spring, design, edc, forged, grinder, hand, knife, made, post, sheath, simple, steel |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Any slip joint makers in East Tennessee | Heidel | The Folding Knife (& Switchblade) Forum | 0 | 03-15-2013 12:25 AM |
Tennessee Twirl | Matt Walker | The Damascus Forum | 18 | 01-18-2007 09:17 PM |
Beware "The Blade Shop" of Tennessee | fultronics | The Trade Report | 1 | 01-17-2006 10:53 AM |
Knoxville, Tennessee gun/knife show from 092901-093001 | Dennis Bible | Knife Making Discussions | 3 | 09-29-2001 04:07 PM |