|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Dumb beginner question about beveling
Hello knife makers!
I am an extreme beginner and I’m in the middle of making my first knife. I have a very basic (and I’m sure very stupid) question. When grinding the bevels before heat treat how much of an edge should you bring them to? I ground till the edge was very thin and basically sharpened. Will this edge be damaged or deformed during heat treat? Should I dull or sand it down to make it less fine? Sorry for the stupid question. |
Tags |
1084, 1095, 52100, back, beginner, bend, blade, blades, ca, carbon, edge, first knife, grind in, grinding, heat, heat treat, knife, knife making, makers, making, quenched, question, sand, steel, thin |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Next dumb question | VanceHanna | The Newbies Arena | 3 | 09-06-2015 06:41 PM |
dumb question | SVanderkolff | The Outpost | 2 | 05-06-2005 04:17 PM |
dumb question? | logan | The Newbies Arena | 1 | 03-18-2003 08:20 AM |
dumb question | Sylvester | Knife Photography Discussion | 5 | 01-05-2002 10:27 PM |
Beginner question | RNickl | The Sheath/Holster Makers Forum | 7 | 10-19-2001 06:18 PM |