|
|
The S.R. "Steve" Johnson Forum Specialized knife making tips, technique and training for "ultra precision" design work enthusiasts. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
416 Bolsters
Greetings Steve,
I have a question about pinning 416 bolsters. I currently use bolsters about 5/8 wide + or - a tiny bit. I use two 3/32" pins to fasten them in place. Are two pins enough? How wide do your bolsters have to be before you use more pins? and how many do you use? What grit do you flatten your bolsters to before fastening them on the knife?Thanks. |
Tags |
a, back, bolster, bolsters, choose, epoxy, flat, heat, knife, make, making, material, pinning, pins, polish, problem, question, small, solder, stainless, surface, tang, tiny |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bolsters | KevBooth | The Newbies Arena | 6 | 03-29-2018 08:25 AM |
Bolsters on or off? | Russ Sutton | Fine Embellishment | 2 | 10-27-2005 12:55 PM |
? for Don re bolsters | SVanderkolff | The Newbies Arena | 1 | 12-08-2002 04:22 PM |
Bolsters | RickNJ | Fit & Finish | 3 | 06-28-2002 09:56 PM |