|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Just talked to Aldo......new steel
Well not actually talked, more like we chatted in email. He said they started bringing in 80CrV2. He said, "It's kind of like 5160 on steroids. It has 30 points more carbon and .15 to .25 Vanadium and the heat treat is the same and the stuff is tougher then 5160 ever could be." Looks like I might have something new to try when I make an order.
|
#2
|
||||
|
||||
Is this some stuff that Aldo had specially made for him? I ask because I know of this steel, and it's specs in general are pretty wide...
C: 0.45-1.00 V: 0.10-0.30 Cr: 0.40-1.20 Mo: 0.25 Mn: 0.9 Unless Aldo had the specs narrowed down for this steel, the Carbon and Chromium variances could be a real bugger to work with. You can work your butt off to figure out the heat treating for it, and then the next batch, if the specs are way different, you have to start from scratch. __________________ WWW.CAFFREYKNIVES.NET Caffreyknives@gmail.com "Every CHOICE has a CONSEQUENCE, and all your CONSEQUENCES are a result of your CHOICES." |
#3
|
|||
|
|||
Not real sure, didn't have a long convo with him. He just told me the heat treat was the same as 5160. Not real sure if he had the specs narrowed or not. He just mentioned it because I asked him about his 5160. Not real sure if I want to go with that or 01Tool.
Last edited by Hurley; 09-09-2013 at 05:47 PM. |
#4
|
|||
|
|||
I'll shoot him a follow up e-mail tomorrow and ask
|
Tags |
5160, art, heat, heat treat, made, make, scratch, steel |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
aldo 's steel | claymoore | The Newbies Arena | 10 | 02-03-2013 08:54 AM |
Who is Aldo? | Shankmaker | The Newbies Arena | 7 | 12-29-2008 10:28 PM |
Metallurgy of Steel for Bladesmiths & Others who Heat Treat and Forge Steel | Julie Coffey | Ed Caffrey's Workshop | 11 | 06-20-2008 11:23 AM |
Question about honing steel or sharpening steel | Dan Metsker | The Newbies Arena | 1 | 12-09-2004 01:54 PM |
Epoxy Steel To Steel And Pin For Bolster | ORYXMAN2003 | Ed Caffrey's Workshop | 6 | 02-24-2004 10:08 PM |