|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
first attempt at brass guard didnt go well...
Yall have been very good at giving me knowdledge and being patient with me so i am turning to you all once again!
I did my first attemp at a brass guard this weekend, the front against the blade turned out great, however when i soldered it the flux ran through to the back side against the handle and i when i sanded it off i can not get the scratches out no matter what i do. I have went all the way up to 600 grit sandpaper and even back down to 120 and started over going up to 800 again and it just gets worse. It is an oval guard so it is not sanded down to the handle, it has about 1/4" all the way around the handle. What can i do to get the scratches out? Will rubbing compound and a polish wheel do it? |
Tags |
antler, back, bee, blade, brass, building, clean, fixed blade, flat, guard, guards, handle, hidden, knife, knives, photo, polish, press, sand, sanding, satin finish, solder, surface, tang, weld |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ok, how do I bend 1/4 inch brass for a guard? | ricky_arthur | The Newbies Arena | 3 | 02-23-2013 08:52 AM |
brass guard on stag handle | bbrocksc | Fit & Finish | 4 | 06-13-2012 11:10 AM |
Check out my latest lignum vitae brass guard, O-1 | Mitchell H. | The Newbies Arena | 7 | 09-03-2005 09:36 AM |
First Bowie/mortised tang/black &white ebony and brass guard | Mitchell H. | The Newbies Arena | 7 | 07-06-2005 01:51 AM |
nickel silver/brass guard stock | John Frankl | Ed Caffrey's Workshop | 1 | 11-06-2001 04:49 PM |