|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
This steel is messing with me! Keeps bending
Hi guys.
This thin steel stock i bough it proving really difficult for me to handle, and i donøt know whats going on! :-) When i received the steel it was a little bit bend, i didn't think much of it because i though i could just straighten it. I made it nice and straight and started sanding it away. I went to check the straightness and it was bend right back to where it started?! This keeps happening! I think it might have been stores on a roll and some how wants to go back to that shape. But how do i straighten it now? I can imagine that when i do the HT it will bend a lot. |
Tags |
annealing, back, bee, bend, bending, flat, handle, made, sanding, steel, thin |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Just messing with flappy wheels and sketchy steel. | AllanBeasley | The Newbies Arena | 11 | 03-07-2015 12:05 AM |
I think I have been messing up | spc13b | The Newbies Arena | 7 | 12-07-2012 07:55 AM |
Tim Zowada's "Bending and busting steel" demo, Ashokan 2006 | Chris Meyer | Heat Treating and Metallurgy | 0 | 09-20-2006 06:27 PM |
bending a katana (and steel choice) | Andrew Garrett | Knife Making Discussions | 14 | 09-11-2006 02:09 AM |
Bending Steel | David Johansen | The Newbies Arena | 10 | 02-04-2004 02:05 PM |