|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1/2 in. X 3/4 in. cut
Just areminder folks, tape up those blades. I was drilling holes in the handle, it wasn't even sharp yet, the metal caught, the knife spun and viola I'm bleeding all over the shop. I know better,but I got so involved in what I was doing that I forgot the first and last rule inside any shop--- SAFETY!!!
Another lesson learned. |
#2
|
||||
|
||||
Ouch
Sorry to hear of your misfortune. Also, just a tip: When drilling handles drill through the left side of the knife blank. Picture the blade spinning and instead of the sharp part being the leading edge the spine is leading.
__________________ Regards, Fred "Great spirits have always encountered violent opposition from mediocre minds". Albert Einstein |
#3
|
|||
|
|||
If you were drilling on a drill press, there is a cheap vise you can get that bolts to the drill press table and works like vise grips, i have one and it comes in very handy!!! Also i have been there too on the spining the metal around, just never sliced myself!! Sorry to hear that!!
Ross |
Tags |
blade, knife |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|