|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
ran into problem doing handle
So i ran in a problem i was grinding a handle after epoxy and got it all done before noticing there is a small gap between tang and material on the front of the spine idk maybe not enough epoxy or wiped to much off either way its there so i am trying to figure out how to fill it . its small so i cant fit a "oral syringe" in there that i use to measure the epoxy i tried a insulin syringe with a metal tip but the epoxy is to thick to squeeze out the tip the gap is so small i think if i just poured the epoxy on and hoped for the best i think it would be to thick to seep down into the gap.....its small but noticeable has this happened to any one any ideas how to fix it?
|
Tags |
degrees, epoxy, glue, grinding, handle, handles, heat, how to, kitchen, kitchen knife, kitchen knives, knife, knives, loveless, make, material, metal, problem, rivets, sand, screws, small, tang, tips, weld |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can anyone see a problem? | Suicycle | The Display Case | 15 | 04-14-2007 10:21 PM |
problem | obe | Fit & Finish | 2 | 03-31-2007 12:50 PM |
Got a handle problem... | jwfilion | The Newbies Arena | 4 | 11-05-2004 08:18 AM |
Finishing the handle-guard, handle-tang junction? | C_Claycomb | Fit & Finish | 7 | 06-25-2003 01:33 AM |
Problem? | logan | The Newbies Arena | 4 | 03-21-2003 04:18 PM |