|
|
Knife Making Discussions A place to discuss issues related to all aspects of the custom knifemaking community. |
|
Thread Tools | Display Modes |
#46
|
||||
|
||||
Darrin,
Michael Walker Pretty simple site, scroll down until you see RWL-34 no pattern. You have to call. He's out of .2 right now but will be getting some in a week or so. I have some on back order now. There is only one US distributer. The rub is that this stuff is much cheaper in Europe than it is here. Try one piece to mirror up and you will be amazed. If you aren't going for a mirror, stick with 154CM. Don Cowles posted this Canadian supplier in an older thread: James Downie 10076 Estate Drive Port Franks, Ontario, CANADA N0M, 2L0 (519) 243-2290 |
#47
|
|||
|
|||
Thanks Tracy, I'll have to get some...but not in the 1/4 inch that I was thinking about! man, that size is sure expensive! the smaller sizes didn't seem too bad though...
-Darren __________________ Gas Forges, Refractory, & Knifemaking Supplies Refractory.EllisCustomKnifeworks.com Visit the Forge Gallery - forge building resource pages ForgeGallery.EllisCustomKnifeworks.com |
Tags |
blade, knife, knife making, knives |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|