|
|
The Folding Knife (& Switchblade) Forum The materials, techniques and the designing of folding knives. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Guidance please
First time here and just ordered a knife kit to get started learning to make knives. I ordered the SS-3.0 and the email I received said it could be converted to automatic with a spring and drilling a hole, but I can't find which spring or where to drill the hole. Where might I find out?
Thanks! |
#2
|
|||
|
|||
Following this thread. I am looking for the same info for the 2.0. If you find anything out, please let me know.
|
#3
|
||||
|
||||
Hello, I'm not exactly sure - as I've not done it before. But from what I gather you use a counter bore to cut out room for the spring around the pivot of the super squirt...maybe the auto- tools are on this page?
http://www.knifekits.com/vcom/index....tk03pmag91psh5 Good luck! __________________ AT "We shall walk with a walk that is measured and slow, And watch where the chalk-white arrows go To the place where the sidewalk ends." Shel Silverstein |
Tags |
automatic, first time, kit, knife, knife kit, knifekits, knifekits.com, knives, make, pivot, super squirt, switchblade, tools |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
What to buy? Need a little guidance please. | Naboyle | The Newbies Arena | 7 | 10-19-2013 10:36 PM |
need guidance | uncleglenny | The Newbies Arena | 15 | 11-07-2009 01:44 AM |
Need Guidance | Georgiaboy | The North Carolina Custom Knifemakers Guild Forum | 1 | 01-13-2008 07:31 PM |