|
|
The Supply Center What's Hot ... and where the deals are! Supplies are our specialty ... |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
0-80 taps
Best source for quality 0-80 taps at a good price? Just looking for a few.
Thanks, Chuck __________________ A knife is no More Than an Iron Tooth! Visit me at the Chesapeake show Dec 9th. Member of the Knifemakers Guild! Visit my webpage at www.gedraitisknives.com |
#2
|
||||
|
||||
these taps tend to dull quicker but are much less brittle..when i was making body jewelry with 00-90 0-80 1-72 2-56 taps these were the only ones i would use (after a period of trial and error) the added cost of replacing dull taps was made up by not losing time with broken taps...of course if you have a tapping head you wont need to worry about breakage.
the source is reactive metals studio www.reactivemetals.com the cost was about $2 each ..i also loved their mini dies for getting into tight areas -Jason Aube |
#3
|
|||
|
|||
I have decalred a moritorium on 0-80 screws until I have built a proper tapping jig but as for taps I purchase the cheapest variety that I can find and throw them out when they get dull. Less bother than removing a broken tap.
__________________ george tichbourne www.tichbourneknives.com sales@tichbourneknives.com |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|