|
|
Fine Embellishment Everything from hand engraving and scrimshaw to filework and carving. The fine art end of the knifemaker's craft. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Engraving on golf clubs
I have some putters that I have been asked to engrave on. Does anyone have any exprience on engraving golf putters. I was told that they are made of 431 Stainless Steel and are heat treated. They are hard and look to be a casting. Has anyone annealed, engraved, and retempered any of these putters or someting similar. Any advice, experience or thoughts would be appreciated.
Jim |
#2
|
||||
|
||||
I've seen guys have the line-up markings enhanced. Most clubs are very soft from a RC standpoint. I've used a dremmel to work on the grooves and they generally melt like butter.
I'm a candidate to have a putter engraved if you get it worked out. Good luck and please post some photos when you're done!!! Alex __________________ Alex Whetsell [======]~~~~~~~> Atlantavirtual.com Atlanta NOC |
#3
|
||||
|
||||
Steve Lindsay has done some fine work on golf clubs- check out his web site.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|